Tecnatool

[Holzflorian]

Hallo in die Runde,
hat jemand eigene Erfahrungen mit der kleinen von Teknatool?
Ich meine diese:

http://www.teknatool.com/products/lathe ... ometII.htm

Weis jemand ob sie einen echten FU hat?

Danke schon mal vorab für die Auskünfte.

[Klotzkopf]

guxu hier

http://www.teknatool.com/products/lathe ... 202013.pdf

schnippel------------------------------------------------
The Variable-Speed DC (Direct Current) Motor
The DC motor contains brushes that contact the commutator. It is very important to
allow between 30 to 45 minutes of 'run-in' time of these brushes before any turning or significant
load is applied. This should be done in the higher rpm range. A clicking or swishing noise in the
motor is normal which will reduce as the brushes wear in. During normal operation, 5 minutes of
warm-up may also be required on cold weather days.
schnippel-----------------------------------------------

GleichstromMotor mit Kohlebürsten -> Kein FU -> Gesteuerter Gleichrichter